SrTiO3 (100) 10x10x1.0 mm Epi polished wafer 2 SP - STOa101010S2

SrTiO3 (100) 10x10x1.0 mm Epi polished wafer 2 SP - STOa101010S2SrTiO3 single crystal provides a good lattice match to most materials with Perovskite structure. It is an excellent substrate for epitaxial growth of HTS and many oxide thin films. SrTiO3 single crystal has also been used widely for special optical windows and as high quality sputtering target. MTI has the full production line to manufacture first the high purity SrTiO3 powder, then the single crystal boules and finally the epi polished substrates in

Notes Please do not over tighten the three hex screws on the flanges to avoid overpressure incidents

( Modified structure from April 10 for quicker release )

Instruction Video

01 steps provides ease of use when measuring a variety of surfaces

and report immediately to carrier/MTI

Size:                                           2" x 2"x 0

100% pure lead foil tape coated with a compounded synthetic rubber adhesive system which exhibits excellent adhesion to a wide variety of surfaces

One set of crimping die for CR2032

Carbon Fiber

therefore it has attracted wide attention in the fields of energy storage

Resistivity:                    10-15 Ohms/cm  (If you would like to measure the resistivity accurately

Water Flow Requirement Minimum water flow 150-200 cc/min