Kidde FX-IDC1B

Kidde FX-IDC1BThe FX IDC1B connects a normally open, alarm, supervisory, or monitor type dry contact initiating device circuit (IDC) to the Kidde control panel. This module is for Class B circuit operation. The device address is set using the two rotary switches located on the front of the module. One device address is required. The module is configured to operate as an alarm latching device type from the factory. When the NO contact of an initiating device is

and traditional 2 wire smoke detectors

32‐character LCD (liquid‐crystal display) annunciates system status and events

UL listed for outdoor use

The exclusive Sequential Logic Input (SLI) provides added security that is not offered in any other REX device

The power supplies are programmed and controlled through the main control panel P-Link bus

and service features with point and module capacities suitable for a wide range of system applications

The DSC rate of rise heat detector is suitable for use in most applications that require heat detection

The card enables two independent RS-485 circuits for network data and digital audio communications

PS Series provides auxiliary power

mass notification

The way this type of sensor works depends on its purpose and the material to be detected

Simplified Installation: Installation is made easier with the PIBV2’s single side conduit entrance