1990 Aria Pro II Japan SB-800 Neckthrough Bass (See Through Red)

1990 Aria Pro II Japan SB-800 Neckthrough Bass (See Through Red)The Aria Pro II SB 800 was a Japanese made bass that was one of the few SB models continuing the neckthrough legacy after the closure of the Matsumoku factory. Favoured by bass legends including Cliff Burton, Jack Bruce and John Taylor, the SB 800 features a Sen ash body, a smooth maple walnut transmit neck (and heel less cutaway) and a rosewood 24 fret fingerboard (42mm brass nut with a reasonably slim neck profile, 34" scale length). Weighs just

built with a maple body around a hefty centre-block along with a slim 60's maple/walnut neck (43mm nut width

Tune-O-Matic bridge gives you the tuning stability that's often lacking from Jaguar models and the Schecter Deluxe tuners work a treat

Top - Solid Cedar

The finish is clear and shiny with a few cosmetic blemishes

Japanese ST-VINTAGE single coils

Candy Apple Red with a matching headstock and mint green plastics

slim and fast maple neck with a 22 fret ebony fingerboard

HS3 in the middle and a Dimarzio DP117 in the neck

this is a seldom seen Stratocaster from the masters of the quirky vintage guitar

The hardware has some surface corrosion but still functions perfectly

Previous owner had it set up right handed (hole drilled on the lower horn where an old strap pin was installed) however now it's back to it's original LH setup

Good used condition as pictured with some sticker tan on the body and pickguard as pictured