Li-Ion Battery Cathode - Aluminum Foil Single Side Coated by LiNiCoAlO2 (241mm L x 200mm W x 0.06mm T), 5 sheets/bag - bc-af-241NCA-SS811

Li-Ion Battery Cathode - Aluminum Foil Single Side Coated by LiNiCoAlO2 (241mm L x 200mm W x 0.06mm T), 5 sheets/bag - bc-af-241NCA-SS811This electrode sheet is based on Aluminum foil coated by Lithium Nickel Cobalt Aluminum Oxide (NCA811) on a single side and can be used as the cathode of Li Ion battery 5 sheets bag SPECIFICATIONS Material: LiNiCoAlO2 ? Ni: Co: Al = Ni: Co: Al=8. 15: 1. 5: 0. 35) Current collector (substrate): Aluminum foil (16 microns, area desnityof 4. 22mg cm2) Coated Area: 241mm L x 175mm W. The edge width of blank area is 12. 5 mm for each side. Single sides area

Resistivity:                             > 50Ohms/cm (If you would like to measure the resistivity accurately

( see picture below right )

Length:  100 mm

Al-Clad CR2032 case to avoid corrosion when battery >4

One pack of 50160 accessories

and lower cost for Li-ion battery cathode

Length:    60 mm (2

Such an alumina tube can be used at operating temperatures to 1700 oC in both oxidizing and reducing atmospheres

you can prepare a 15mm ID x 24mm OD O-ring as a reference ring for a three-electrode split test cell ( The special 24mm OD X 15mm ID O-ring cutting die can be ordered in the options bar )

graphene film thickness varis from 1 - 10 layer carbon

Single crystal  KTN   ( KTa 1-X NbXO3 ) is transparent isotropic crystal with very large electro-optic coefficients of about >600

0 First charge and discharge efficiency (%)