L-008 1/10 Scale Racing Car / Truck Body Shell Simple 10 LED Light Kit 6v JR

L-008 1/10 Scale Racing Car / Truck Body Shell Simple 10 LED Light Kit 6v JR2 Red LEDs. 4 Amber LEDs. 4 White LEDs. To suit 1 10 scale models car or truck shells. Simple 10 LED lighting system, recommended to be used with lighting buckets (not included). Simple on off switch. This set would be powered by the receiver (any 27mhz 35mhz 40mhz AM FM or 2. 4ghz) which must be running by an esc or have a 6v DC input if using two servos for nitro models.

92mm inner diameter (check the hub carrier is smaller than this)

30cm long end to end (wire)

recommended to be used with lighting buckets (not included)

Will not be suitable for other engines unless meets below requirements: Crankshaft output thread is 6mm in diameter (to accept 6mm thread flywheel axle)

4mm wide - outer diameter 28

To fit 540 motors 35mm in diameter

To set up the fail safe

12mm hex hub - 56mm inner diameter (check the hub carrier is smaller than this) - 84mm outer diameter - 33mm wide - Edge of wheel to edge of12mm hex center is 17mm

420mm Long - 155mm Wide - 115mm High - 250mm between center of wheel arches

Part Number 60102B Made by CPV

Complete with JST red 2 pin connector red n black wire n dean pin

Recommend engine size