Shrink chuck 4,5° HSK 63 - 14 - 95

Shrink chuck 4,5° HSK 63 - 14 - 95Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Clamping range h6 (nominal size only)

With fi ne adjustment carriage to feed the slider finely

Warranty : 1 year in normal statement

Length: 62mm

One turning toolholder - four possibilities:

ISO-Metric Thread

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

Jaws with grip serrations und fine step for workpieces with max

Alignment of component reference surfaces or edges

Mode : Peak

Adaptive interface machine direction (ADINTMS): BMT driven turret interface -size BT65A

Carbide tipped scriber with clamp