Milling arbors for screw-in cutters HSK 63 - M10 - 51 - LB25

Milling arbors for screw-in cutters HSK 63 - M10 - 51 - LB25Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For safe clamping of taps in end mill holders according to DIN 1835 B

For the storage of collet chuck

automatically inversion of measuring direction

With internal cooling

With clamping screw

Surface hardened HRC 58~60

coolant pipes is screwed to the cylinder head screw integrated in the adapter

With balanced clamping nut All holders are made of forged steel

For longitudinal and plane turning

because only the shaft diameters and the squares must fit

For mounting the coolant tubes in PSK toolholders

3 µm radial run-out with a 2 µm clamping nut