6" OD X 48" Long

6" OD X 48" LongStandard aluminum intake tubing. 6061T6 alloy . 125 wall thickness. Cuts easily with a hack saw or band saw. About 1 1 2 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

and Water across a vast range of applications throughout the Motorsport and Automotive industry

5" with some effort (it will also clamp down onto 2-1/4" easily)

This reducing insert adapts a 3" ID intake hose to a 2

This reducing hump hose connects 7" OD and 6" OD intake tubes

5" Fluid Compatibility Petrol

Full 6" leg lengths

This 10" ID 90-degree intake hose can be used any place you need to make a 90-degree bend

and has 3-3/4' long legs

creating more volume internally without increasing height

You install it in the end of the 4

One end goes on 3" OD tubing

This short radius 6" 90-degree intake hose is used when you need to make a tight bend when joining two 6" OD tubes